Fivestar Pump Motor Replacement

	STEP BY STEP REPAIRS

Fivestar Pump Motor Replacement

Open Machine
- Confirm that the power cord is disconnected from the wall.
- Locate the two black caps at the front of the machine and remove them to uncover the Phillips head screw underneath.
- Using a Phillips head screwdriver, remove the two screws and tilt the machine open.

Remove Pump Motor
- Disconnect the pump wiring harness by pulling apart the plastic connector, being careful not to remove wires from the connectors themselves.
- Using a Phillips head screwdriver, locate and remove the four Phillips head screws holding the pump motor in place.
- Disconnect or loosen the two hose clamps located on the two hoses connected to the male nylon elbows on the pump head with a flathead screw driver.
- Remove the two hoses from the pump, making sure you know which hose goes to which port.
- Pull the pump out of the machine.

Replace Pump Motor
- Place new pump motor assembly manufacturer part # into the machine.
- Reconnect wiring harness by connecting the plastic connectors.
- Push grey water hoses back onto the male nylon inlet and outlet ports on the pump head.
- Once the hoses are in place, tighten hose clamps using a flathead screw driver until the hoses are secure.
- Replace the four Phillips head screws to secure the pump to the chassis of the machine using a Phillips head screw driver to complete the repair

Click on any image to get a larger view.